Skip to content
Omnikalc

Bacterial growth calculator: how fast does a culture grow?

Enter the initial cell density, the generation time and the growth time to get the number of generations, the final cell density, the specific growth rate and the time to a target density.

Updated on
Your inputs
CFU/mL

Value out of range

min

Value out of range

h

Value out of range

CFU/mL

Value out of range

Results

Cell density after the growth time

262,144,000 CFU/mL

Number of generations
18.00
Specific growth rate μ
2.079 h⁻¹
Time to reach the target density
6:38:38

Bacteria multiply by doubling. The bacterial growth calculator gives the number of generations, the cell density after a given time, the specific growth rate and the time to reach a target density, from the initial density and the generation time of a culture in the exponential phase.

How the calculation works

  • Enter the initial cell density in colony-forming units per milliliter (CFU/mL) and the generation time, the time for the population to double.
  • Enter the growth time in hours, during the exponential phase.
  • The density after n generations is N = N₀ × 2ⁿ, with n = t / g.
  • Enter a target density to get the time needed. The specific growth rate is μ = ln 2 / g.

Example

A culture of E. coli starts at 1,000 CFU/mL and doubles every 20 minutes. After 6 hours it has gone through 6 × 60 / 20 = 18 generations, so its density is 1,000 × 2¹⁸ = 262,144,000 CFU/mL. The specific growth rate is 2.079 h⁻¹, and it takes 6 h 38 min to reach 10⁹ CFU/mL.

Why it matters

Growth calculations are used in microbiology teaching and in the lab to plan the inoculation of a culture, in the fermentation industry, and in food safety to understand how fast bacteria multiply. They show why a small contamination becomes a large one in a few hours.

Good to know

The calculator assumes that the growth is exponential, without a lag phase, without limitation by nutrients and with a constant generation time. A real culture has a lag phase, and then slows down when it reaches the stationary phase, usually at 10⁹ cells/mL or less. The result is the number of cells, viable or not, as measured by CFU, and the generation time depends strongly on the temperature, the medium and the strain, so measure it for your own conditions.

The exponential growth calculator covers growth in general, the OD600 cell density calculator estimates the density from the optical density, the CFU count calculator gives the density from plate counts, and the log reduction calculator covers the opposite process of killing bacteria.

Frequently asked questions

What is the generation time?

It is the time that a population of bacteria needs to double in number, also called the doubling time. It is about 20 minutes for E. coli in a rich medium at 98.6 °F (37 °C), 30 to 60 minutes for many pathogens, 90 minutes or more for slow growers, and many hours for mycobacteria. It depends on the species, the temperature, the medium and the oxygen.

What are the phases of bacterial growth?

A culture goes through a lag phase, in which the cells adapt and do not divide much, an exponential (log) phase, in which the population doubles every generation time, a stationary phase, when the nutrients run out or the waste builds up, and a death phase. The formula of this calculator applies only to the exponential phase.

Why do bacteria in food become a danger so fast?

Because the growth is exponential. With a doubling time of 20 minutes, one cell becomes 8 in an hour, 64 in two hours and more than 260,000 in six hours. This is why the rule of thumb for food safety is not to leave perishable food in the temperature danger zone, between 40 and 140 °F (4 to 60 °C), for more than two hours.

How does the specific growth rate relate to the doubling time?

In the exponential phase, N = N₀ e^(μt), so the specific growth rate is μ = ln 2 / g, or about 0.693 / g. For g = 20 min, μ = 2.08 h⁻¹. The rate is used in fermenters and chemostats, where a steady growth can be kept by feeding fresh medium at a rate equal to μ.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.