Skip to content
Omnikalc

Maneuvering speed calculator

Enter the maneuvering speed and the stall speed at maximum weight, the load factor limit and the current weight to get the maneuvering speed and the stall speed at your weight.

Updated on
Your inputs
kt

Value out of range

kt

Value out of range

g

Value out of range

lb

Value out of range

lb

Value out of range

Results

Maneuvering speed at the current weight

89.8 kt

Stall speed at the current weight

46.3 kt

Reduction of the maneuvering speed
9.2 kt
Va computed from stall speed and load limit
99.4 kt
Weight as a share of the maximum
82.4 %

The maneuvering speed calculator gives the maneuvering speed Va and the stall speed at the current weight of an aircraft from their values at maximum weight, using the square root law, and compares Va with the value computed from the stall speed and the load factor limit.

How the calculation works

  • Enter Va and the stall speed at maximum weight, and the load factor limit.
  • Enter the maximum weight and the current weight.
  • Read Va and the stall speed at the current weight.

Example

An aircraft with a maneuvering speed of 99 kt and a stall speed of 51 kt at 2550 lb now weighs 2100 lb, which is 82.4 % of the maximum. Its maneuvering speed falls to 89.8 kt, a reduction of 9.2 kt, and its stall speed to 46.3 kt. From the stall speed and a limit of 3.8 g, Va would be 99.4 kt at maximum weight.

Why it matters

The calculator helps pilots and instructors who fly with a partial load, one pilot and little fuel, and who must know that the speed to use in turbulence or for abrupt maneuvers is lower than the figure at maximum weight printed in the handbook.

Good to know

Va is a calibrated airspeed and applies to full control deflection of one axis at a time, not to combined inputs or to a gust. The square root law is an approximation that holds well for a normal weight range. Always follow the figures in the flight manual of your aircraft, which may give Va for several weights. A lower Va means that you must slow down earlier in rough air, and the stall speed also rises in a bank, so the safe margin shrinks.

The aircraft turn performance calculator shows the load factor in turns, the density altitude calculator shows the effect of the weather, the crosswind component calculator helps landings and the climb gradient calculator checks departures.

Frequently asked questions

What is the maneuvering speed?

The maneuvering speed Va is the highest speed at which a full, abrupt control input will stall the wing before the load on the airframe goes beyond its limit. Below Va, the wing stalls and relieves the load before the structure can be overstressed. Above it, a sharp input can damage the aircraft.

Why does Va fall when the weight falls?

The stall speed is proportional to the square root of the weight, and Va = Vs × √n, where n is the limit load factor. A lighter aircraft stalls at a lower speed, so it reaches the load limit at a lower speed too. The new value is Va × √(W / Wmax), so Va falls by about 3 knots for every 5 percent of weight lost.

Is Va a protection against turbulence?

Va protects against the load of a full control deflection, but it does not protect against every case. In severe turbulence, a pilot flies at or below the turbulence penetration speed given in the manual, which is often close to Va at maximum weight. Reduce the speed at a lighter weight, and avoid abrupt inputs in rough air.

Where do I find the figures?

The pilot operating handbook gives Va, often for one or two weights, and the stall speed with flaps up and down. Use the values of the same weight and the same configuration, as calibrated airspeed, and apply the manual for any limit specific to your aircraft.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.