Skip to content
Omnikalc

Well drawdown calculator: how far will the water level fall?

Enter the pumping rate, the transmissivity, the radius of influence and the distances to get the drawdown at the well, the drawdown at an observation point and the specific capacity.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

Value out of range

Results

Drawdown at the well

11.20 ft

Drawdown at the observation point
3.52 ft
Specific capacity
8.93 gpm/ft

When a well is pumped, the water level around it falls in a cone. The well drawdown calculator uses the Thiem equation. It takes the pumping rate, the transmissivity of the aquifer, the radius of influence, the radius of the well and the distance to an observation point and gives the drawdown at the well, the drawdown at the observation point and the specific capacity.

How the calculation works

  • Thiem equation for steady flow to a well in a confined aquifer: s = Q ÷ (2π × T) × ln(R ÷ r), where Q is the pumping rate, T the transmissivity, R the radius of influence and r the distance from the well.
  • Drawdown at the well uses the radius of the well for r. Drawdown at the observation point uses the distance you enter.
  • Specific capacity = pumping rate ÷ drawdown at the well. A high value means a productive well, because it gives a lot of water for each unit of drawdown.
  • The calculation converts every input to cubic metres per day and metres, then shows the answer in feet and gallons per minute per foot.

Example

A well of radius 0.33 ft pumps 100 gpm (545 m³/day) from an aquifer with a transmissivity of 15 000 gpd/ft (186 m²/day) and a radius of influence of 500 ft (152 m). The drawdown at the well is 545 ÷ (2π × 186) × ln(152.4 ÷ 0.1) = 3.41 m, which is 11.2 ft. At 50 ft from the well it is 3.5 ft. The specific capacity is 100 ÷ 11.2 = 8.9 gpm per foot.

Why it matters

The drawdown tells you whether a pump can lift the water and how much the water table falls near neighbours. Well drillers and hydrogeologists use it to size a pump, to forecast the effect on nearby wells, and to read the results of a pumping test.

Good to know

The equation is for steady flow in a confined aquifer, and an unconfined aquifer needs a different form, with heads squared. A real aquifer is rarely uniform, the flow takes time to reach a steady state, and the well itself adds loss from the screen and the casing that is not counted here. Use the result for a first estimate and have a professional design a real well.

The well pump cost calculator estimates what a pump costs to buy and run, and the pump power calculator gives the power needed to lift water against a head.

Frequently asked questions

What does the Thiem equation assume?

It assumes a confined aquifer of constant thickness, uniform and extending far in every direction, with steady flow to a fully penetrating well. The drawdown then depends on the logarithm of the distance. The assumptions fit a long pumping test in a large, confined aquifer.

What is transmissivity?

It is the rate at which water flows through a full thickness of an aquifer under a unit gradient, equal to the hydraulic conductivity multiplied by the thickness. A good sand and gravel aquifer is above 1 000 m²/day, while a clay or tight rock may be below 1.

What is the radius of influence?

It is the distance from the well beyond which the pumping has no measurable effect on the water level. It is not easy to measure and changes with time and with the pumping rate. Typical values range from tens of metres to several hundred, and the result depends only on its logarithm.

How do I use specific capacity?

Divide the pumping rate by the drawdown. A well with 10 gpm per foot gives 10 gallons per minute for each foot of drawdown, so a drawdown of 20 ft allows 200 gpm. Specific capacity falls as the pumping goes on and as the well ages or clogs, so it is also a health check for a well.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.