Skip to content
Omnikalc

Factor of safety calculator: how strong is your part compared to its load?

Enter the yield strength, the cross-sectional area, the load and the required factor to get the stress, the factor of safety and the allowable load.

Updated on
Your inputs
psi

Value out of range

in²

Value out of range

lb

Value out of range

Value out of range

Results

Factor of safety

2.70

Meets the required factor of safety
Stress in the part
13,333 psi
Largest load allowed at the required factor
27,000 lb
Share of the yield strength used
37%
Margin over the required factor
35%

Every engineered part is designed to carry more than it ever should. The factor of safety measures that margin: the strength of the material divided by the stress it actually sees. This calculator finds the stress from the load and the section, the factor of safety, the largest load allowed at a required factor, and how much of the material’s strength you are using.

How the calculation works

  • Stress = applied load ÷ cross-sectional area
  • Factor of safety = yield strength ÷ stress
  • Allowable load = yield strength × area ÷ required factor
  • Share of strength used = stress ÷ yield strength
  • Margin = factor of safety ÷ required factor − 1

The load is assumed to act along the axis of a uniform section: a straight pull or push through the centre.

Example

A steel bar with a yield strength of 36,000 psi and a section of 1.5 in² carries 20,000 lb. The stress is 13,333 psi, so the factor of safety is 2.70, using 37 % of the yield strength. With a required factor of 2, the bar can carry up to 27,000 lb, and it has a margin of 35 % above the requirement.

Why it matters

A part with no margin fails the first time something unexpected happens: a heavier load, a flaw in the material or a bit of corrosion. A part with far too much margin wastes material, weight and cost. The factor of safety makes the trade-off visible and gives a number to check against a code or a rule of thumb.

Good to know

The values for yield strength come from the material specification and vary with grade, temperature and processing. Welds, holes and sharp corners concentrate stress, so the local value can be several times higher than the average. Long, thin members can buckle well before they yield. Fatigue from repeated loading lowers the safe stress. This tool is for education and is not a substitute for engineering design.

The beam deflection calculator checks bending, the Euler buckling calculator checks slender columns, and the compression spring calculator handles springs.

Frequently asked questions

What is the factor of safety?

It is the ratio between what a part can withstand and what it actually carries. A factor of 2 means the part could carry twice the applied load before it reaches its limit. It covers uncertainty in loads, materials, workmanship and wear.

What factor of safety should I use?

It depends on the field, the consequences of failure and how well the loads are known. Machine parts with known loads often use 1.5 to 3, lifting equipment and structures use more, and anything carrying people calls for the figure set by the applicable code.

Is the stress based on yield or ultimate strength?

This calculator uses yield strength, the stress at which the material starts to deform permanently, because a part that yields has failed in practice. Some codes use the ultimate strength with a higher factor, so follow the rule that applies to your design.

What does this not cover?

It treats a simple axial load on a uniform section. Bending, buckling of slender members, fatigue, stress concentrations at holes, welds and temperature are not included, and each can reduce the real factor well below this figure.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.