Skip to content
Omnikalc

Rotary encoder resolution calculator

Enter the pulses per revolution, the quadrature multiplier, the screw lead and the speed to get the counts per revolution, the angular and linear resolution, the count rate and the maximum speed for your counter.

Updated on
Your inputs

Value out of range

mm

Value out of range

rpm

Value out of range

kHz

Value out of range

Results

Counts per revolution

4,000

Angular resolution
0.0900 °
Angular resolution in arc-seconds
324.0 ″
Linear resolution on the screw
1.250 µm
Count rate at the given speed
200.0 kHz
Within the counter limit
Maximum speed for the counter
15,000 rpm

The rotary encoder resolution calculator gives the counts per revolution, the angular resolution, the linear resolution on a screw, the count rate at a given speed and the maximum speed a counter can follow.

How the calculation works

  • Enter the pulses per revolution and pick the quadrature multiplier.
  • Enter the screw lead, the shaft speed and the maximum count rate of the counter.
  • The calculator gives the counts per revolution, the resolutions, the count rate and the maximum speed.

Example

An encoder of 1,000 pulses per revolution read in ×4 mode gives 4,000 counts per revolution, which is 0.0900°, or 324.0 arc-seconds. On a screw of 5 mm lead, each count is 1.250 µm. At 3,000 rpm the count rate is 200.0 kHz, within a 1,000 kHz counter limit, which would allow up to 15,000 rpm.

Why it matters

The calculator helps automation engineers, makers building CNC machines or 3D printers, and students who choose an encoder and check that a counter or microcontroller can keep up.

Good to know

The resolution is not the accuracy: mechanical errors, eccentricity and signal quality limit the real precision. A gear or belt between the encoder and the load multiplies the resolution seen at the load by the ratio. Interpolation electronics can multiply the counts further, for example by 10 or 100, for high-resolution applications. For a rack and pinion or a belt, replace the screw lead with the travel per revolution of the pinion or pulley. Microcontroller interrupts can handle only a limited number of edges per second, so a hardware counter is a better choice at high rates. Absolute encoders give the position directly, without a reference move.

The servo inertia ratio calculator sizes motors and loads, the gear contact ratio calculator covers gear meshing, the rack and pinion travel calculator relates rotation to distance and the UART baud rate calculator checks serial links.

Frequently asked questions

What is the resolution of an encoder?

The pulses per revolution is the number of cycles on one channel. A quadrature encoder has two channels shifted by a quarter cycle, and counting every edge of both gives four counts per cycle. The angular resolution is 360° divided by the counts per revolution.

What is quadrature decoding?

The two channels A and B are 90° out of phase, and the order of their edges gives the direction of rotation. Reading only channel A rising edges gives ×1, both edges of A give ×2 and all four edges give ×4, the usual choice for the best resolution.

Why check the count rate?

A counter or controller input can only accept so many counts per second. At high speed and high resolution the rate may exceed it, and counts are lost. The maximum speed shown is the limit for the counter you enter.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.